SUS301-CSP-SEH
1 source records. Standards, editions and conditions are presented separately; matching grade names do not establish interchangeability.
Refer to each source for mass fractions and analysis type. Missing values are not treated as 0. Manufacturer typical values, standard guarantees and measured heat results must remain separate. Use the material selector for calculations and condition selection.
Open condition selection, comparison and carbon-equivalent tools for SUS301-CSP-SEH →SUS301-CSP-SEH · JIS G 4313:2011
Chemical composition source verified; this does not verify every standard clause, actual supply or measured heat results
- Material category
- Stainless steel
- Material form
- Cold-rolled stainless spring strip
- Original record status
- Original standard verified
- Standard edition
- JIS G 4313:2011
- Table / clause
- Main-text Table 1—5
- PDF page references
- 4、5
- Unit
- Mass fraction (%)
- Analysis type
- Ladle analysis
Carbon-equivalent reference
Composition
| Element | Composition requirement |
|---|---|
| C | ≤ 0.15 (lower limit not stated) |
| Si | ≤ 1.0 (lower limit not stated) |
| Mn | ≤ 2.0 (lower limit not stated) |
| P | ≤ 0.045 (lower limit not stated) |
| S | ≤ 0.03 (lower limit not stated) |
| Ni | 6.0 ～ 8.0 |
| Cr | 16.0 ～ 18.0 |
Applicability and limitations
Table 1 in the original Japanese 2011 edition: SUS301-CSP; Table 5 temper condition SEH; The hardness for this temper condition must not be applied to other temper conditions. ; Table 5: Vickers hardness ≥530 HV in cold-rolled or annealed/solution-treated condition. ; Table 2—4 gives heat-analysis mass percentages; Strength/elongation in Table 7 applies only upon request of the purchaser, and tensile tests may be omitted for thicknesses less than 0.30 mm; Values after precipitation hardening in Table 6 must be judged separately according to processing conditions. ; This standard covers cold-rolled stainless steel strip for springs; it does not establish cold-heading wire suitability, stock availability or a supply guarantee. ; Table 5, Note a: SEH falls within the EH category range and applies only when specified by the purchaser..