KGMS1215

1 source records. Standards, editions and conditions are presented separately; matching grade names do not establish interchangeability.

Refer to each source for mass fractions and analysis type. Missing values are not treated as 0. Manufacturer typical values, standard guarantees and measured heat results must remain separate. Use the material selector for calculations and condition selection.

Open condition selection, comparison and carbon-equivalent tools for KGMS1215 →

KGMS1215 · Kobe Steel manufacturer specification (section 6-21)

Chemical composition source verified; this does not verify every standard clause, actual supply or measured heat results

Material category: Carbon steel
Subcategory: Free-cutting steel
Material form: Reference record
Original record status: Manufacturer source verified
Document edition: Publication edition not stated in the document
Document title: Wire rod and bar specification tables
Table / clause: 6-21
PDF page references: 36
Unit: Mass fraction (wt%)
Manufacturer: Kobe Steel

Carbon-equivalent reference

Estimate from manufacturer-published ranges, not a standard guarantee or measured heat result; formula applicability requires review against the application and process.

IIW / CEV：0.2333–0.3567 Known-item contribution, not a complete value; missing Cr, Mo, V, Ni, Cu CEV = C + Mn/6 + (Cr + Mo + V)/5 + (Ni + Cu)/15; an engineering estimate of welding cold-cracking susceptibility for carbon and low-alloy steels.

Pcm（Ito–Bessyo）：0.0700–0.1700Known-element contribution; incomplete value; missing Si, Cu, Cr, Ni, Mo, V, B Pcm = C + Si/30 + (Mn + Cu + Cr)/20 + Ni/60 + Mo/15 + V/10 + 5B; mainly used for low-carbon low-alloy steels, particularly modern low-carbon pipeline steels; more relevant when C is approximately no higher than 0.11%.

CET：0.1400–0.2500 Known-item contribution, not a complete value; missing Mo, Cr, Cu, Ni CET = C + (Mn + Mo)/10 + (Cr + Cu)/20 + Ni/40; used in welding preheat assessment for ferritic steels, subject to the applicability conditions of EN 1011-2.

Composition

Element	Composition requirement
C	≤ 0.09 (lower limit not stated)
Mn	1.4 ～ 1.6
P	0.04 ～ 0.09
S	0.34 ～ 0.46

Applicability and limitations

Original composition for free-cutting steel in the Kobe Steel catalogue, section 6-21 (PDF page 36), mass fractions wt%; This is not the original JIS/SAE standard. Actual supply and process applicability require separate confirmation.

Composition conditions

Original table in section 6-21, mass percent; Dashes and unlisted elements are not entered as zero.
The 6-21 table lists only C/Mn/P/S; other elements are unspecified and are not entered as zero.
The manufacturer catalogue does not identify the publication edition; Catalogue information does not establish current supply dimensions.

Verification notes

Chemical values checked cell by cell against the manufacturer original table; columns joined during extraction in Section 6-17 were additionally checked manually against the original image.