ELCH2S
1 source records. Standards, editions and conditions are presented separately; matching grade names do not establish interchangeability.
Refer to each source for mass fractions and analysis type. Missing values are not treated as 0. Manufacturer typical values, standard guarantees and measured heat results must remain separate. Use the material selector for calculations and condition selection.
Open condition selection, comparison and carbon-equivalent tools for ELCH2S →ELCH2S · Kobe Steel manufacturer specification (section 6-6)
Chemical composition source verified; this does not verify every standard clause, actual supply or measured heat results
- Material category
- Soft magnetic materials
- Subcategory
- Soft magnetic materials
- Material form
- Wire rod
- Original record status
- Manufacturer source verified
- Document edition
- Publication edition not stated in the document
- Document title
- Wire rod and bar specification tables
- Table / clause
- 6-6
- PDF page references
- 27
- Unit
- Mass fraction (wt%)
- Manufacturer
- Kobe Steel
Classification basis (does not replace original-source composition verification)
Reuse the verified soft-magnetic-material application in Kobe Steel catalogue Section 6-6 (PDF page 27); No standard guarantee for electromagnetic pure iron or supply by Creation Group is claimed.
Carbon-equivalent reference
Estimate from manufacturer-published ranges, not a standard guarantee or measured heat result; formula applicability requires review against the application and process.
Composition
| Element | Composition requirement |
|---|---|
| C | ≤ 0.02 (lower limit not stated) |
| Si | ≤ 0.03 (lower limit not stated) |
| Mn | 0.23 ～ 0.33 |
| P | ≤ 0.03 (lower limit not stated) |
| S | 0.02 ～ 0.03 |
| Cu | ≤ 0.25 (lower limit not stated) |
| Ni | ≤ 0.15 (lower limit not stated) |
| Cr | ≤ 0.15 (lower limit not stated) |
Applicability and limitations
Original composition for soft magnetic materials in the Kobe Steel catalogue, section 6-6 (PDF page 27), mass fractions wt%; This is not the original JIS/SAE standard. The manufacturer catalogue does not state a publication year; actual supply and application require separate confirmation; This does not establish a supply commitment from Creation Group.
Composition conditions
- Original-table mass percentage, Section 6-6; Dashes and unlisted elements are not entered as zero.
- The manufacturer catalogue does not identify the publication edition; Catalogue information does not establish current supply dimensions.