42CRMOS 4
1 source records. Standards, editions and conditions are presented separately; matching grade names do not establish interchangeability.
Refer to each source for mass fractions and analysis type. Missing values are not treated as 0. Manufacturer typical values, standard guarantees and measured heat results must remain separate. Use the material selector for calculations and condition selection.
Open condition selection, comparison and carbon-equivalent tools for 42CRMOS 4 →42CrMoS 4 · DIN EN 10263-4-2002
Chemical composition source verified; this does not verify every standard clause, actual supply or measured heat results
- Material form
- Reference record
- Original record status
- Original standard verified
- Standard edition
- DIN EN 10263-4-2002
- Table / clause
- Table 2
Carbon-equivalent reference
Composition
| Element | Composition requirement |
|---|---|
| C | 0.38 ～ 0.45 |
| Si | ≤ 0.3 (lower limit not stated) |
| Mn | 0.6 ～ 0.9 |
| P | ≤ 0.025 (lower limit not stated) |
| S | 0.02 ～ 0.04 |
| Cu | ≤ 0.25 (lower limit not stated) |
| Cr | 0.9 ～ 1.2 |
| Mo | 0.15 ～ 0.3 |
Applicability and limitations
The original webpage states DIN EN 10263-4-2018; The composition in this record was actually verified against DIN EN 10263-4-2002; the edition is now identified as 2002 according to the original evidence; The original official German edition of 2018 remains unavailable; edition EN2017 is not automatically treated as the original DIN. ; DIN EN10263-4:2002-02 adopts EN10263-4:2001; the edition relationship is expressly identified on the cover; Heat-analysis mass percentages. ; Historical Table 2/3 contains no optional Al addition note for 2017; newer-edition conditions are not applied. ; Table 2, note c permits an agreed carbon range of width .04%; tabulated defaults are unchanged without a specific agreement. ; Table 2, note d and Table 3, note c permit agreed lower Si, considering effects on properties/hardenability; no range is invented where none is specified. ; Unlisted elements are not entered as zero; Table 2, note a: intentional additions without purchaser consent are prohibited except to finish the heat; residuals may be present but must not impair properties. ; Table 2, note b permits specified deviations where hardenability is required, except for P/S; The default composition range is not widened here. ; Mechanical properties, delivery and hardenability require separate verification; suitability for forming a specific component requires separate confirmation.